CAB PX Series, Руководство оператора, Страница: 20 / 28

20 20 7 Fault Correction
7.3 Error Messages and Fault Correction
Error message Cause Remedy
ADC malfunction Hardware error Switch the print module off and then on.
If error recurs call service.
Barcode error Invalid barcode content, e.g. alpha-
numeric characters in a numerical
barcode Correct the barcode content.
Barcode too big The barcode is too big for the allocated
area of the label Reduce the size of the barcode or move it.
Battery low
Battery of the PC card is flat
Replace battery in the PC card.
Buffer overflow
The input buffer memory is full and the
computer is still transmitting data. Use data transmission via protocol (preferably
RTS/CTS).
Card full No more data can be stored on the
memory card Replace card.
Device not conn. Programming addresses a non-existent
device Either connect this device or correct the
programming.
File not found
Requested file is not on the card
Check the contents of the card.
Font not found Error with the selected download font Cancel current print job, change font.
FPGA malfunction Hardware error Switch the print module off and then on.
If error recurs call service.
Head error Hardware error Switch the print module off and then on.
If error recurs replace printhead.
Head open Printhead not locked Lock printhead.
Head too hot Printhead is overheated After pausing the print job will be continued
automatically. If the fault recurs repeatedly,
reduce the heat level or the print speed via
software.
Invalid setup
Error in the configuration memory Re-configure print module.
If error recurs call service.
Memory overflow
Current print job contains too much
information, e.g. selected font, large
graphics Cancel current print job.
Reduce amount of data to be printed.
Name exists
Duplicate usage of field name in the
direct programming
Correct programming
No DHCP server
The print module is configured for
DHCP, but there is no DHCP server,
or the DHCP server is not currently
available.
Switch off DHCP in the configuration, and assign
a fixed IP address.
Please contact your network administrator.
No label found There are labels missing on the label
material Press pause key repeatedly until print module
recognizes the next label on the material.
The label format as set in the software
does not correspond with the real label
format Cancel current print job.
Change the label format set in the software.
Restart print job.
No label size
The size of the label is not defined in
the programming.
Check programming.
No Link No network link Check network cable and connector.
Please contact your network administrator.
For operation without network connection set
parameter "Network error" to
Off

Configuration Manual.
No record found
Refers to the optional memory card;
database access error Check programming and card contents.
No SMTP server
The print module is configured for
SMTP, but there is no SMTP server,
or the SMTP server is not currently
available.
Switch off SMTP in the configuration.
Caution! Then a warning cannot be sent by
e-mail (EAlert).
Please contact your network administrator.