CAB eos 1, Руководство оператора

Страница: 17 / 36

16 17 17 4 Loading Material
4.3 Adjusting the Label Sensor
i
Notice!
When the printer is delivered the label sensor is positioned in
the middle of the paper feed. Thus, the label sensor must only be
adjusted if:
• material with reflex or cut-out marks, which are not in the middle,
• multi-strip material with an even number of strips,
• material with irregularly shaped labels
are used.
1
3
2
Fig. 9 Adjusting the Label Sensor
The sensor position (3) is marked with a yellow LED in the sensor retainer.
1. Press on the knob for adjusting the label sensor (1) using a pointed object,
so that the knob pops out of the bore of the housing .
2. Position the sensor (3) by turning the knob (1) so that the sensor can
detect the front edge of the label in the direction of paper flow or the reflex
or cut-out mark.
3. Push knob (1) back into the bore of the housing using a pointed object
until it snaps into place.