CAB E2, Руководство оператора, Страница: 40 / 55

40 cab Produkttechnik GmbH
Replacing Thermal Print Head
1. Switch off the power and wait for both LEDs to go off.
2. Unlatch the print head module.
3. Remove the ribbon.
4. Push the print head firmly into the casing and shift it to the left. It will release from the
module.
5. Disconnect the print head cable.
6. Dissemble the print head and the mounting bracket by releasing screws.
7. Replace with new print head, then resemble the print head module in reverse order. Be
careful not to touch the print head elements.
Caring for Your Printer
Clean the following areas of the printer after 8 rolls of label stocks have
•
been used. In
each case, use a cotton bud dampened with alcohol. Do not soak the cotton bud
excessively.
Note : Always switch off the power before cleaning.
Cleaning
Thermal Print Head
Thermal paper stock and ribbon will release debris on the print head and degrade
printing quality. Clean the print head with methanol or isopropyl alcohol with a cotton
bud. Do not touch the heater element with your fingers. Debris or dirt on the roller
should be cleaned with alcohol.
Paper Sensor
Debris or dirt on the paper sensor will cause a miss-read or unstable detection of the
label gap. Clean with a cotton bud dampened with alcohol.