CAB E2, Руководство оператора, Страница: 21 / 55

cab Produkttechnik GmbH 21
Performing Calibration
1. Keep pressing the feed button while turning on the power, until the printing motor
becomes activated.
2. The calibration has been performed while the printer automatically feed label stock for
certain length.
Note: This step is very important and must always be carried out whenever media is being
changed. Failure to do so will result in miss-detection of the label sensor.
Printing Configuration Report
1. Keep pressing the feed button while turning on the power, until the printing motor
becomes activated.
2. After feeding 12-inch blank media, the printing motor will suspend for one second, then it
will print out the configuration profile. This profile states the firmware version, ROM
checksum, RS232, thermal transfer/direct thermal settings, hardware configuration and
font types.
3. At PPLB emulation, the printer will enter character dump mode. To exit from dump
mode, just press the feed button again.
Resetting the Printer to Factory Default Settings
1. Turn on the printer and wait for 5 or more seconds.
2. Press „Feed“ button for about 10 seconds, then the „Ready“ indicator and „Power“
indicator will go off in order.
3. While two indicators become lit again, release the feed button.
4. At this moment, the printer will feed the label stock 12 inches in length, and come back
to the factory default settings.
Note : All settings are stored in non-volatile E2PROM andcannot be destroyed even turn
off the printer.