16
16
5.6
Mounting the Pad
4
2
3
1
5
7
8
9
10
6
1. Insert the two pins (9) on the pad (10) into the
holes on the bottom of the pad holder (6).
2. Fix the pad (10) with the screws (4) to the pad
holder (6).
3. Insert the vacuum tube (2) and the support air
tube (3) into the appropriate push-in-fittings (7, 8)
of the pad.
4. Insert the connector (1) into the female connector
(5) of the product sensor and tighten the nut.
Fig. 11
Mounting the pad
!
Attention!
To avoid possible collisions of the pad with other parts of the printer-applicator system, please roughly
align the pad in all directions (
„6.1 Pad Adjustments“) before connecting the applicator to the
compressed air supply!
5.7
Mounting the Blow Tube
2
3
1
Fig. 12
Mounting the blow tube
It is possible to rotate the blow tube to optimize the support air for the take over procedure of the label from printer to
applicator.
1. Loosen screw (1).
2. Put in the blow tube (3) into the blow tube hole B (2).
3. Tighten screw (1) lightly to secure it.