11
Fig. 7
Mounting the applicator to the printer
!
Attention!
Initiation, adjustments and changing of parts is to be performed by qualified service personal only.
!
Attention!
Disconnect the printer from the power supply before mounting the applicator!
Ensure a stable placement of the printer!
Connect the compressed air only after mounting the applicator to the printer!
To clean the applicator and printer it is sometimes necessary to turn away or even dismount the applicator from the
printer.
Take care not to adjust the setting screws, throttle valves or other alignment elements. This will enable use of the
applicator directly after cleaning.
Pivot Away/Dismount the applicator
1. Loosen thumbscrew (5) and swing the applicator away.
2. Disconnect SUB-D 15 male connector (6) from the female connector (7) of the printer.
3. Loosen screw (4) and remove the locking plate (3) from the hinges.
4. Lift the applicator from the hinges.
Mount the applicator
5. Hang on the applicator with the female parts (1) of hinges on the hinges parts (2) of the printer.
6. Connect the SUB-D 15 male connector (6) to the female connector (7) of the printer.
7. To secure the applicator against slipping out of hinges, loosen screw (4), move metal part (3) under the hinge and
tighten screw (4).
8. Swing the applicator to the printer and tighten the thumbscrew (5).
1
1
2
2
6
7
3
4
5