13
/
20
3.5 Shock Alert ,Crash accident alert and Crash accident data logger
CAT-1X box is with built-in 3D Acceleration sensor (G sensor) on board.
The device use this G sensor created three functions.
1.
Shock Alarm
CAT+-1X will detect all X,Y,Z acceleration always, any changes in all X,Y,Z axis will be calculated, every changes
over 0.1G, system calculated for shocking once, every 5Seconds scan and calculate once.
We use 5seconds average shocking times as shocking sensitivity to generate Shock Alarm alerts in Armed Status.
1=most sensitive
200= Most insensitive.
SMS commands for adjusting shocking sensitivity:
*1234*VS*xxx# (xxx=001-200)
Switch On/Off Shocking Alarm SMS commands:
*1234*H#
<Switch On shocking Alarm>
*1234*N#
<Switch Off Shocking Alarm>
2.
Accident Alert for A/B/C Numbers
By configure Cat-1X installation position and X,Y,Z axils value to setup the accident alert value limit as trigger
conditions.
Cat-1X provides two ways to configure:
-
Configure By SMS commands
*1234*CS*m,x.x,y.y,z.z# (Configuration SMS Command)
Note:
Check as following picture which we defined the X,Y,Z direction for the accelerator sensor. And M is the
movement sides serial NO. It can be any one as user self-define. Just make sure it’s the movement facing side.
-
Configure by Configurator program:
