C2R Colibri 5 Series, Руководство пользователя

Страница: 32 / 168

Colibri serie 5 : User’s guide
© 2000-2008 C2R Technologie, Sarl. All rights reserved.
32 32
Rev. C
Manual Trigger, Low Power
Note: For RS-232 mode only.
The imager powers down until the trigger is pulled. When the trigger is pulled, the imager powers
up and operates until there is no triggering for the time set with the
Low Power Time-Out bar
code below. There is a delay of up to one second in operation when the imager is first triggered,
but there is no delay when operating in low power time-out mode.
Low Power Time-Out Timer
Note: For RS-232 mode only.
Scan the Low Power Time-Out bar code to change the time-out duration (in seconds). Then scan
the time-out duration (from 0-300 seconds) from the inside back cover, and Save. Default = 120
seconds.
If the unit remains idle during the low power time-out interval, the unit goes into low power mode.
Whenever the trigger is enabled, the low power time-out timer is reset.
Note: This time-out does not begin until the imager time-out setting has expired.
Snap and Ship
Snap and Ship mode allows you to bypass the decoder and ship an image directly to the host. In
this mode, an image is taken and shipped upon each trigger pull, instead of being sent to the
decoder. Snap and Ship is useful when you are using your own decoder.
Note:
Snap and Ship mode only works if the imager is connected via an RS-232 serial port or
via a USB keyboard (see Plug and Play on page 19). If you use Snap and Ship when the imager
is connected to another interface, it calls the decoder after each image ship, but only to look for
menu codes