5
8.
To reset to factory default
a.
Disconnect power from the unit.
b.
Press and hold the # key whilst powering the unit back up.
c.
On hearing the two “Di” sounds, release the # key, system is now back to factory settings.
Please note only installer data is restored, user data will not be affected.
9.
Anti- tamper alarm
The unit uses an LDR (light dependent resistor) as an anti-tamper alarm. If the keypad is removed from the
cover then the alarm will operate.
10.
Sound and light indication
Operation Status
Red Light
Green Light
Yellow Light
Buzzer
Power on
-
Bright
-
Di
Stand by
Flashing
-
-
-
Press keypad
-
-
-
Di
Operation successful
-
Bright
-
Di
Operation failed
-
-
-
DiDiDi
Enter into programming mode
Solid
-
-
-
In the programming mode
-
-
Solid
Di
Exit from the programming
Bright
-
-
Di
Open the door
-
Solid
-
Di
Alarm
Flashing
-
-
Alarm
11.
Detailed programming guide
11.1 User settings
To enter programming mode
.
*
.
Master code
.
#
.
999999 is the default master code
To exit programming mode
.
*
.
Note that to undertake the following programming the master user must be logged in
To change the master code
.
0
. .
New code
.
.
#
. .
New code
.
.
#
.
The master code can be 6 to 8 digits
Setting the working mode:
Set valid card users only
Set valid card
and
PIN users
Set valid card
or
PIN users
.
3
.
.
0
.
.
#
.
Entry is by card only
.
3
.
.
1
.
.
#
.
Entry is by card
and
PIN together
.
3
.
.
2
.
.
#
.
Entry is by either card
or
PIN (default)
