18 / 24
in the end of these operations, the Liner will be well laid out and therefore you will be able to access the
tub without shoes so as not to scratch the PVC sheet, to complete the installation of the accessories.
You will need a screwdriver, a cutter and the screwdriver.
After checking again that there are no manufacturing imperfections, partially fill the pool using a garden
rubber. It will be sufficient to fill the tank with about 10-15 cm of water.
Bring in tension Liner and accompany the foot of the towel in perfect adhesion with the surfaces of the
tub. We proceed with the flanging of the accessories (skimmer, vents and headlight pass-through): a
Phillips screwdriver, the cutter and the screwdriver with cross inserts will be needed.
Make a 45 ° cross cut with the cutter, starting from the center of the pre-drilling template on the panel.
4 wings will be generated at 45 °, which will be turned up on the rear face of the panel and fixed to it by
means of adhesive tape, taking care that the Liner is well stretched on the surface.
Then proceeds with a partial fixing of the flange to the accessory, using the screws supplied with the latter.
Once the correct correspondence with the holes on the accessory has been verified, the screws must be
tightened.
06/12/2019
Ver.00
MEDITERRANEA
