CM6533,CM6533N,CM6533X1,CM6533DH
USB Audio Chip
Page
6
/
60
www.cmedia.com.tw
Rev.1.7
Copyright© C-Media Electronics Inc.
1
Description and Overview
The CM6533/CM6533N/CM6533X1/CM6533DH is a USB 2.0 audio chip built-in 8051 for flexible applications. With
integrated Tri-Colors PWM LED driver and two (2)-channel ADC/DAC and S/PDIF interface makes it suitable for
headset, docking, speaker and microphone applications. The internal 8051 can also be developed to a lot of different
applications, such as Microsoft™ Lync/Skype/VoIP device, Android Phone or Tablet/Slate docking device. The
CM6533/CM6533N/CM6533X1/CM6533DH is compatible with USB Audio Class 1.0 and USB 2.0 Full-Speed, thus it can
plug & play without any additional software installation on major operating systems. The internal DAC and ADC
support from 8 ~ 96 KHz sampling rate and 16/24 bits resolution. The hardware of CM6533, CM6533N, CM6533X1 and
CM6533DH are all the same and they only differ in firmware and software.
The CM6533/CM6533N/CM6533X1/CM6533DH integrates equalizer on both playback and recording paths to
compensate the frequency response of microphone and headphone.
The CM6533/CM6533N/CM6533X1/CM6533DH also integrates 256K Byte flash(Including 32KB F/W programming size)
and crystal but requires few passive components to make a finish product. Thus, it can save the total BOM cost and
PCB area can be smaller.
2
Features
2.1
USB Compliance
USB 2.0 Full-Speed compliant
USB Audio Class 1.0 compliant
USB Human Interface Device (HID) Class 1.1 compliant
Supports USB suspend/resume/reset functions
Supports control, interrupt, bulk, and isochronous data transfers and overview
2.2
Integrated 8051 Microprocessor
Embedded 8051 micro-processor to handle the command/protocol transactions
Embedded 256K Byte SPI Flash(Including 32KB F/W programming size)
32K Byte RAM for firmware extension and plug-in
HID interrupts/buttons/functions can be implemented via firmware codes
Provides maximum hardware configured flexibility with firmware code upgrade
VID/PID/Product String can program by firmware
2.3
Control Interface
Master/Slave I2C control interface, bus speed supports 100 and 400kbit/s
One 4-wire SPI mater/slave interface, bus speed supports from 150k to 12Mbit/s
12 GPIO pins and firmware programmable
JTAG debug interface
GPIOs are configured as HID key and LED indicators
Tri-Colors PWM LED Driver
2.4
General
Crystal-less (embedded crystal function)