C-LITE C-STRIP-B-LIN Series, Руководство по установке

Страница: 4 / 24

Document: Date:
Created By: INSTALLATION INSTRUCTIONS
C-STRIP-B-LIN Series
http://lighting.cree.com/warranty | 866.924.3645
LPN00625X0001A1 07-17-2021
TMT
1. Detach the LED assembly by starting at one end of the first
4' section and pressing each side of the base. Pull the LED
assembly away from the base. Continue this along the entire 4’
section until the base and LED assembly are separated. See
Figure 4. Repeat for second 4' section.
2. After separating the bases and LED assemblies, disconnect the
quick connects attaching the bases to the LED assemblies. Set
the LED assemblies aside until the base is mounted and wired.
See Figure 5.
3. Insert the connecting bracket into one of the bases at the end with
no end plate. See Figure 12.
4. Connect the two fixtures bases together using the (4) latches on
the connector plate. See Figure 13.
5. Remove the appropriate knockout and feed the supply wires into
the housing. Install the fixture base to the mounting surface using
customer supplied hardware appropriate for the mounting surface.
Pass mounting hardware through (4) keyhole slots on the ends
and near the center of the base. See Figure 14.
6. With the fixture base installed, make wiring connections per the
appropriate wiring diagram in the Electrical Connections section.
NOTE: If using the occupancy sensor accessory, please refer
to OCCUPANCY SENSOR ACCESSORY section for installation
and programming of occupancy sensor before proceeding to the
Electrical Connections section.
7. Select desired wattage and CCT. See Figure 7.
8. Reconnect both quick connects that were disconnected in Step 2.
See Figure 8.
9. Reattach the (2) LED assemblies to the (2) fixture bases. The LED
assemblies should “click” into place. See Figure 15.
10. Supply power to fixture.
8' FIXTURE INSTALLATION- DIRECT MOUNT
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 15
FIGURE 16