5
Step-by-step guide to complete your ZX-HD before use
ByteDelight does not take responsibility for errors in this process - check the “In the box” paragraph
for a service in case you don’t want to perform these steps yourself.
1.
Assembling your Raspberry Pi Zero
The first step is to solder the 2x20 male pin header block to the Raspberry Pi Zero at the side shown
in the photo underneath:
Carefully check all soldering contacts before assembling the Raspberry Pi on to the ZX-HD!
2.
Mounting the top circuit board to the lower circuit board
The ZX-HD consists of 2 circuit boards to make it possible to ship the interface in a letterbox (instead
of a package, which would be a lot more expensive to ship).
Top circuit board with ‘ZX-HD’ text
Lower circuit board with serial number
Carefully insert the male pin header of the top baord into the female pin header of the lower board:
Result:
