3
Installation on JUMP unit
Cut off the mains power supply before carrying
out any operation.
Using a screwdriver, open the passage for the
cables (A). If necessary, lower the gearmotor
as described in the instructions for the JUMP
unit:
A
Fasten the batteries to the gearmotor using the
bracket and screws supplied. Pass the con-
nection cable through the cable passage A:
If you previously lowered the gearmotor, return
it to its operating position.
Open the gearmotor assembly following the in-
structions supplied with the JUMP unit.
Disconnect the battery charger connector
(shown in the fi gure) from the control station’s
cover:
On the battery charger, re-
move the screw on the side
opposite the terminal board.
Using the screw supplied, install the battery
charger as shown in the fi gure:
Connect the batteries and the battery charger
as described in the “Connections” section.
Close the gearmotor assembly following the
instructions supplied with the JUMP unit.
TCIC 3,5x9,5
TCIC 2,9x22
