6
Installation on FREEDOM unit
A
B
Cut off the mains power supply before carrying
out any operation.
Open the electromechanical operator with the
control station following the instructions sup-
plied with the FREEDOM unit.
Install the batteries as shown in the fi gure (no
screws or brackets required) and pass the bat-
tery connection cables through slot A:
Disconnect the battery charger connector
(shown in the fi gure) from the control station’s
cover:
Fasten the battery charger as shown in the
fi gure, applying double-sided adhesive tape in
zone B:
Connect the batteries and the battery charger
as described in the “Connections” section.
Close the electromechanical operator with the
control station following the instructions sup-
plied with the FREEDOM unit.
