BYOGuitar.com JEM, Руководство по сборке

Страница: 4 / 11

Here is the order of operations to complete the guitar:

Install the neck.

Install the tremolo and locking nut

Sand the body and neck.

Sand some more!

Finish the body and neck.

Assemble the guitar.

Wire it up.

Final set up and adjustments.

Plug it in and enjoy!
It’s recommended that you assemble your guitar before applying the finish. Drill all the holes to
eliminate any accidental chipping of the finish while drilling. Fit the neck and locate the bridge before
finishing the guitar. After the finish is complete all you should need to do is put it together and do some
fine-tuning.
Always center punch the hole locations before you drill; this will ensure that the holes are properly
located (very important with bridge screws). If you don't have direct access to a drill press, have a friend
with a drill press drill a series of holes through a block of wood that correspond to the holes required for
your bridge. Then put the block on top of the body and use it to guide your drill bit.