BYOC Mega Chorus & Vibrato Kit, Инструкция по эксплуатации

Страница: 23 / 29

Step 4: Install the footswitch. Orient the footswitch so that the flat sides of the solder
lugs are like the diagram below. NOTE: There are no actual number markings on the
footswitch. There are two correct ways you can orient the footswitch. They are both 180
degrees of each other. Either way is fine. It does not matter as long as the flat sides of
the solder lugs are running horizontal, not vertical.
FOOT SWITCH SOLDER LUG DESIGNATIONS
Step 5: Make a jumper between lugs 3 & 6 from clippings from the resistors. Simply use
your needle nose pliers to make a U shape & insert into lugs 3 & 6, then solder.
Step 6: Install the foot switch into the enclosure.