BYOC Large Beaver NYC, Инструкция по эксплуатации

Страница: 18 / 23

Step 3a: Make a jumper between lugs 3 & 6 from clippings from the
resistors. Simply use your needle nose pliers to make a U shape & insert into
lugs 3 & 6, then solder.
Step 3b
: Connect a wire to LUG 4 that also jumpers to LUG9. Strip about
1” off one end. Make sure there is enough insulated wire to make the
connection to the TIP of the in jack. Carefully tin the stripped end. You
may want to twist the wire strands together tightly before tinning. Thread
the stripped end through LUGs 4 and 9. This can be a little tricky. If this
part is too frustrating for you, you can just run a separate wire to connect
LUGs 4 and 9. Just be sure to solder the two wires at LUG 4 at the same
time so you only need to make one solder joint.