BYD P20PS, Руководство оператора

Страница: 15 / 27

OPERATING
OPERATOR MANUAL 25
P20PS
26 OM-P20PS2019001-EN
TRANSPORTING LOADS
Loading
1. Load on the ground
(1) Drive the forklift carefully up to the load and brake the forklift to a stop.
(2) Lower the forks.
(3) Insert the forks under the load.
(4) Lift the forks.
(5) When transporting, drive with caution, pay attention to the route condition and to the
people ahead and maintain a proper driving speed. Transport the load to the designated
place.
Danger
(1) When approaching the load, do not travel at high speed to avoid crashing.
(2) Do not stay beneath the raised load.
Caution
When transporting load , the load should be securely fastened on a pallet with the gravity
center well centered and proper stacking height. Do not damage the packaging of the goods and
the handling personnel should bear the responsibility of safe loading.
Travel
(1) When travelling with load, make sure that the load is well centered on the forks.
(2) After the load is placed on the forks, keep the mast tilted backwards and raise the forks
above the floor.
(3) During the travelling of the forklift, do not tilt the mast forward or try raising the forks to
avoid the danger of forklift nose over and losing stability.
(4) If the stacked loads are high and affect the operator
’
s visibility of the route ahead,
operate the forklift in reverse except when the forklift is climbing the slope or inclines.
Warning
(1) When driving the forklift on a slope, keep the forks always facing the uphill direction and
downhill direction in contrast and drive in turtle speed mode.
(2) Do not cross or turn around on a slope.
Caution
Have a second person as lookout if the visibility of the operator is reduced.
Unloading
(1) Drive the forklift carefully up to the stacking destination and decelerate when approaching.
(2) Lower the forks.
(3) Slowly remove the forks from the bottom of the load.
(4) After driving the forks out, start the next task.
Exiting
(1) Lower the forks after unloading.
(2) Turn the key anticlockwise to OFF position and take it out.
(3) Press down the emergency disconnect switch.
(4) Exit.