BYD F3DM, Руководство пользователя

Страница: 38 / 214

- 38 -
F3DM Owner’s Manual
function mode; please refer to “Settings
of Optional Functions”.
If no operations on the remote control
within 30 seconds after remove the key
and closing all the doors, the car will
enable anti-theft function automatically.
Under anti-theft status, insert the key
into ignition switch, then the signal
lights flash for caution but the alarm will
not sound; when you turn the ignition
key to “ON”, anti-theft function will be
released (to unlock in anti-theft mode
is only limited to this status); also you
can press UNLOCK button to release
anti-theft function.
Disable Anti-theft Function
Press UNLOCK button on the remote
control, and then all the doors will be
unlocked to disable anti-theft function.
The system will give a sign about the
vehicle conditions as follows:
● If anti-theft function is not enabled,
the turn signal lights flash twice.
● If anti-theft function is enabled, the
turn signal lights flash three times and
anti-theft warning light flashes rapidly;
when you turn the ignition switch to
“ON”, the indicator will go out.
When anti-theft function is disabled,
the rear interior light and ignition key
warning light (optional) will be on for
about 30 seconds, even if no doors are
open. (Delay time for two lights can be
changed. For details, please refer to
“Settings of Optional Functions”).
If anti-theft function can not be disabled
by remote control, you disable it by
the key; just turn the ignition switch
from “ACC” to “ON” ten times within 15
seconds after opening the doors.
After anti-theft function is disabled,
The doors will be unlocked for 30
seconds, all the doors will be locked again automatically and enter anti-theft
status if no door is opened.
Enable Anti-theft Function
If any abnormalities below are detected
by the anti-theft system, the signal
lights will flash and the alarm will sound
for about 30 seconds.
y
Any doors open.
y
Insert the ignition key.
y
Reconnect the battery or anti-theft
controller.
Restart Alarming
Under the following conditions, alarm
will be enabled again after it stops.
● Any door is opened.
● Insert the key into ignition switch.
The alarm sounds, the turn signal lights
flash for about 30 seconds and then
stop for 15 seconds, which will repeat
continuously three times. The times of
使用手册小330.indd 38 2011-4-13 18:36:42