1
The instructions for use and installation regulation should be read carefully.
It contains important information on installation, use and maintenance of the
Wine Dispenser.
The manufacturer shall not be held liable if the instructions
and notices in the operating manual are not observed.
2
SAFETY PRECAUTIONS
General
•
Only a trained installer/authorized service technician of By the Glass is
allowed to perform repairs to the unit. Any unauthorized repair may void
your warranty.
•
If a part is damaged, unplug the Wine Dispenser and contact By The Glass.
Setup and Placement
•
Never place the wine dispenser on its side.
•
Do not install the unit close to inflammables.
•
Do not position the wine dispenser near sources of heat, such as stoves,
heating radiators etc as this will negatively impact the cooling efficiencies.
•
The wine dispenser should not be exposed to the constant sunlight.
•
When installing the wine dispenser, be sure to allow the unit time to
acclimate to changes in temperature/humidity prior to use.
•
The wine dispenser should be positioned on a flat even surface to avoid
excessive noise caused by vibrations of the cooling system.
•
Ventilation holes + panels on the back and on sides of the dispenser
should never be covered up. The back side should be placed 3 inches from
the wall as a minimum and the side of the wine dispenser should be a
minimum 4 inches to provide for air supply.
•
Cooling unit should be placed at a well-ventilated service well accessible.
•
If positioning outdoors, be careful about excessive noise and protection
against extreme cold.
Electrical
•
For every cooling unit, a separated electrical group 115 V/16 A and a wall
socket should be available.
•
Only use the approved voltage amount, incorrect voltage could result in the
unit malfunctioning or being damaged, it may also void your warranty.
ion
