STANDARD INSTALLATION
cover screws securely.
Place insert in proper cutout, then push cover against door frame. Tighten both
AS A DOOR STOP.
DO NOT USE ABRUPT BACKCHECK OR EXPECT DOOR CLOSER TO ACT
To increase back-check force, turn regulating screw nearest hinge clockwise.
nearest shaft clockwise. To slow latch speed, turn regulating screw nearest hinge
key(furnished) to adjust speed. To slow main speed of door, turn regulating screw
evenly divided between main swing speed and latch swing speed. Use socket
A 'Normal' closing time from 90° open position to door stop position is 4-6 secs,
MAIN ARM
SCREW
FOREARM
ROD
SCREW
LATCH SPEED
MAIN SPEED
SCREW
BACKCHECK
SCREW
ARM
SCREW
COVER
COVER
SCREW
clockwise.
BACK CHECK
REGULATION:
1"
6.With forearm at right angle to door (90° ),insert forearm set screw and tighten.
5.Open door and insert rod in forearm.
4.Attach shoe to frame as shown.(if more latching power is required,rotate shoe 180°
top of shaft and tighten.
3.Place main arm on top of shaft 100° to closer body,insert arm screw into
(For offset pivots, please increase the marked dimensions by 1/8")
used, locate closer and shoe from CENTERLINE OF PIVOT.
2.Mount closer on door as dimensions shown. Tube end toward hinge. If pivots are
1.Adjust spring power to match door width as indicated by chart on front page.
CLOSER MOUNTED ON DOOR ON PULL SIDE
1"
3"
Screws.
machine screws,Wood screws
4 Holes for Self drilling/tapping
OPENING
6
or 1/4-20 Machine
TO 100°
7-5/16" 11-13/16"
10-13/16"
PRELOAD TO
90°
6-1/4"
TO 130°
"B"
"A"
Screws.
machine screws,Wood screws
2 Holes for Self drilling/tapping
2
11
/1
6"
1/
4"
11/
16"
or 1/4-20 Machine
1
15/16"
A
B
