BW Technologies GasAlertMicro 1, Руководство пользователя

Страница: 25 / 76

GasAlertMicro
Confidence Beep
Confidence Beep
The Confidence Beep tells you the detector is on and the
batteries have sufficient power to respond to a hazardous
level of gas and emit an alarm. Instead of beeping when
battery power is low, the audible alarm beeps (once every 5
seconds) to advise you the batteries have sufficient power.
The Confidence Beep stops when battery power is low.
You can activate or deactivate the Confidence Beep only at
startup.
1. To activate or deactivate the confidence beep, press and
hold
C
then press
A
at startup.
Note: Normal one button startup and shutdown will not
deactivate the Confidence Beep. If the Confidence Beep has
been deactivated it will remain deactivated through future
normal startups.
User Option Menu
Note: If the detector is pass code protected, attempting to
enter the user option menu will cause the detector to prompt
for the pass code before proceeding. See the section “
Pass
Code Protection ”.
User options are:
1. Finish options and exit User Options Menu.
2. Enable or disable latching alarms.
3. Enable or disable “SAFE” display mode.
4. Combustible sensor measuring selection: %LEL or
% by volume. [% by volume for methane only.]
5. Language Selection(s)
6. Enable or disable operation of one or more sensors.
7. Enable or disable Pass Code Protection.
8. Enable or disable automatic Oxygen calibration at start
up.
9. Set Span concentration values
10. Set STEL calculation period
11. Enable or disable “stealth” mode.
12. Datalogger model only:
Adjust real-time clock and calendar.
13. Datalogger model only:
Adjust datalogger sampling rate from 1 to 127 seconds.
Note: The button indicator will be displayed where an
option allows a button press.
To enter the user options menu, press
G
and
H
simultaneously and hold for 5 seconds until the display
reads:
13