℃
Special function
Special function
Memory program for Boiling Point Test
-It cannot reach 100°C when boil water in the non-zero elevation area, which will cause
failure of work properly(break off too slow or even unable to trip normally) for the ordinary
Health-care Beverage Maker.
-In order to ensure a good using experience for the user on the plateau, an industry’s
advanced boiling point testing technology with the built-in memory chip is adopted by
Buydeem Health-care Beverage Maker, which can be used normally in the plateau area by
just performing a boiling point test.
-The boiling point test is not limited to the plateau area, but also applicable to the plain or
mountainous areas. After the boiling point test, the Health-care Beverage Maker can
work more accurately (better performance than the factory setting).It is recommended to
carry out a boiling point test for the initial use. Upon completion of the test, the chip will
record accurate boiling point data and there is no need for a repeated test when reuse.
Start of the Boiling Point Test
1. Add 1200ml water and it will affect the test
result if there is not enough water or too
much water.
2. Put on the power base with it
unplugged.
3. Press on the buttons of 'Boil' and 'Tea' at the same time, and plug in the power cord.
And you can release the button after a short beep.
①
Press and hold two keys at the same
time
②
Insert the plug in the power supply
4. The light ring of 'Start/Pause' button blinks at this point, and all button indicators blink in
turns after pressing the “'Start/Pause' button. The machine enters the working status
to test the boiling point and finishes automatically after three beeps, then the Health-
care Beverage Maker can be used.
