2. INSTALLATION AND USE
EN
18
2.3
START-UP
Check that the mains power matches that indicated
on the electrical data-plate (fig. 15), the permissible
tolerance range is +/-5%.
Insert the plug in the current socket and start the
compressor by bringing the switch (g) into position “I /
ON” (Fig. 15).
The winder is composed of an automatic locking
mechanism that allows stoppage of the desired length
of hose.
To disable locking, you must pull the hose slightly
outwards and accompany it slowly up to mechanical
stoppage.
On the quick coupling (f) on the end of the hose,
connect the desired accessories (e) (Fig. 16) and
pulling the hose you can easily reach the use point of
the compressed air.
At the end of each use:
- completely rewind the hose by accompanying it to its
compartment;
- stop the compressor bringing the switch (g) to
position “0 / OFF” (Fig.15).
2.4
MOTOR PROTECTION DEVICES (fig.18)
The compressor is equipped with an internal thermal
protection switch with automatic resetting; if it
activates, bring switch G to the OFF position, wait a few
minutes and restart.
The compressor is equipped with an internal thermal
protection switch with automatic resetting; if it
activates, bring switch G to the OFF position, wait a few
minutes and restart.
Only in countries where planned, the protection is
external with manual resetting.
Where there is an external thermal protection switch,
wait a few minutes, before pressing the thermal
overcharge button to reset and start work again.
In the event of subsequent restart where the
protection intervenes again, you are advised to switch
off the compressor, detach the electrical power supply
and contact an authorised support centre.
14
15
ON/OFF
a
b
F1
F2
