9
3. The warranty period will be extended by the time for which the device is in warranty
repair. If the repair finds no defects falling under the warranty, the device owner shall pay the costs
of the servicing technician’s work.
4. The warranty servicing covers defects occurring during the warranty period demonstrably due to
flawed design, flawed workmanship or inappropriate material. Such defects will be repaired by the
manufacturer free of charge. Complaints shall be made by the user with the device manufacturer; the
place of performance is the manufacturer’s registered office.
5. The warranty does not cover defects caused by inexpert handling, overloading, use of wrong
accessories, or interventions by unauthorised persons, natural wear and tear, or damage during
transport. Recognised defects exclude damage occurring due to inadequate care of neglected
maintenance, non-adherence to rules specified in the Manual, using the device for purposes for which
it is not intended, and overloading the device, albeit temporarily.
6. The warranty expires if the user makes any unpermitted modifications or changes to the device,
connects the device wrongly, or has used the device in contravention of technical requirements .
7. The manufacturer is under no circumstances liable for subsequent damage caused by using the device.
This warranty does not under any circumstances constitute the manufacturer’s liability in excess of
the price of the device.
8. Device maintenance and repairs have to use exclusively original parts supplied by the manufacturer
in accordance with their respective instructions for use.
6.1
UNPACKING AND FIRST START
1. Unpack the device and any accessories supplied and check that they are in good order and the device
and the accessories are not damaged. If you find any defects, do not continue !
2. Leave the device to acclimatise for 15 minutes.
3. Remove the sealing ring located under the coolant tank filling hole lid tab. Pull to remove the lid tab
and take out the sealing O-ring. Then push the tab, including the foam gasket, back into the tank lid.
Keep the O-ring for potential future use if sending the machine via a parcel service.
4. If the focusing head is not attached to the grip by default, screw it on.
5. Fill the device with the coolant supplied with the device via the filling hole.
6. Connect the device to a 230V socket and turn it on using the switch at the back of the device .
7. The cooling circuit venting is activated automatically, and the letters “FIL” flash on the display during
this. The coolant level decreases noticeably during the filling .
8. After completion of the venting, turn the device off and add the coolant so that the coolant level is at
the upper edge of the gauge at the back of the device (about 1 cm below the top of the tank).
9. Turn on the device and let the venting proceed. If the level does not sink, the device is filled and vented
correctly. Repeat the procedure as needed.
