![background image](http://html.mh-extra.com/html/bushranger/mc-e/mc-e_owners-operators-manual_2835583016.webp)
_
15
_
Fuel Mixture Chart
Mixing Instructions
IMPORTANT: Never mix petrol and oil directly in the Multi-Cutter fuel tank.
1. Always mix fuel and oil in a clean container approved for petrol.
2. Mark the container to identify it as fuel mix for the Multi-cutter.
3. Use regular unleaded petrol and fill the container with half the required amount of petrol.
4. Pour the correct amount of oil into the container then add the remaining amount of petrol.
5. Close the container tightly and shake it momentarily to evenly mix the oil and the petrol before filling the
tank on the Multi-cutter.
6. When refilling the Multi-cutter fuel tank, clean around the fuel tank cap to stop dirt and debris from en
-
tering the tank during cap removal.
7. Always shake the premix fuel container momentarily before filling the fuel tank.
8. Always use a spout or funnel when fueling to reduce fuel spillage.
9. Fill the tank only to within 10mm from the top of the tank. Avoid filling to the top of the tank filler neck.
Petrol
Two-stroke oil
50:1
25:1
ISO-L-EGC/ EGD ,JASO class FC/ FD,
or equivalent two-stroke oil
ISO-L-EGB , JASO class FB,
or equivalent two-stroke oil
1 litre
20 mL
40 mL
2 litres
40 mL
80 mL
5 litres
100 mL
200 mL
Recommended Oil Type
Only use a two-stroke engine oil formulated for use in high-performance, air-cooled two-stroke engines.
IMPORTANT: Do not use two-stroke oil intended for water cooled outboard motors. This type of two-
stroke engine oil does not have the additives for air-cooled two-stroke engines and
can cause engine damage.
Do not use automotive motor oil. This type of oil does not have the proper additives
for air-cooled two-stroke engines and can cause engine damage.
Recommended Fuel Type
Use clean, unleaded petrol with an octane rating of 85 or higher. Use of unleaded petrol results in fewer
combustion chamber deposits and longer spark plug life. Use of premium grade fuel is not necessary or
recommended.
IMPORTANT: Never use gasohol or alcohol blended fuels in this engine.
Mixing Petrol and Oil
IMPORTANT: The engine used on this Multi-cutter is of a two-stroke design. The internal moving
parts of the engine, i.e., crankshaft bearings, piston pin bearings and piston to cylin-
der wall contact surfaces, require oil mixed with the petrol for lubrication.
Failure to add oil to the petrol or failure to mix oil with the petrol at the appropriate
ratio will cause major engine damage which will void your warranty.