Bushranger BRV2600, Руководство оператора

Страница: 7 / 20

7
WARNING
Danger of fire and burn injury:
• Always use extreme care when handling fuel.
Fuel is highly flammable
• Never operate this blower if fuel system
components are damaged or are leaking.
• Never attempt to refuel the engine while it is
running.
• Never attempt to refuel a hot engine. Always
allow the blower engine to cool before fueling.
• Never smoke or light any fires near the blower
or fuel.
• Always transport and store fuels in an
approved container.
• Never place flammable material close to the
engine muffler.
• Never operate the blower without a properly
functioning muffler and spark arrestor
installed.
• Never operate the blower unless it is properly
assembled and in good working condition.
1. Place the machine on the ground or on a
sturdy work surface, and wipe any debris
from around the fuel cap.
2. Remove the fuel cap.
3. Fill the tank with clean, fresh fuel.
4.
Replace the cap, and wipe away any spilled
fuel before starting the machine.
STARTING THE MACHINE
WARNING
Danger from rotating impeller - the impeller will
rotate whenever the machine is operated. Never
operate this machine unless the intake cover and
machine tubes are properly installed and in good
working order.
Danger from thrown dust or debris - always wear
eye protection when operating this machine.
Never direct the machine stream toward people or
animals
Never operate this machine unless all controls are
properly installed and in good working order.
WARNING
The recoil starter can be damaged by abuse.
• Never pull the starter cord to its full length.
• Always engage the starter before cranking the
engine.
• Always rewind the starter cord slowly.
• Never operate the machine if the tubes are
missing or damaged.
STARTING PROCEDURE
1. Move switch to on/start position
(fig. 7).
2. Prime the fuel system by
repeatedly depressing the fuel
primer bulb until no bubbles are
visible in the fuel discharge line.
3. Cold engine only. Choke the
engine by moving the choke
lever to the up closed
position. (Fig. 8).
4. Place the machine on the ground, and hold
the machine handle firmly with your right
hand.
5. Pull the starter cord slowly until you feel the
engine.
6. Start the machine by pulling the starter cord
upward rapidly. If necessary, repeat step 5 two
or three times until the engine starts.
IMPORTANT
Engine will not start if the safety cover on the
suction side is opened. If tubes are not fitted the
cover must be secured in place with the wing nut.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8