Bushranger BRV2600, Руководство оператора

Страница: 9 / 20

9
• Wear hearing protection when operating this machine.
• Never operate the blower if any component parts are damaged, loose, or missing.
IMPORTANT
• Operate the machine only at reasonable hours, not early in the morning or late at night when people
might be disturbed.
Use rakes and brooms to loosen debris before blowing vacuuming.
• Slightly dampen surfaces in dusty conditions.
• Use the full blower nozzle extension so the air stream can work close to the ground.
• Keep children other bystanders and pets away from the machine while operating.
• Don’t operate the machine near open windows.
WARNING
Never allow children or anyone unable to fully understand the directions giver in this manual to use this
product.
IMPORTANT
Whilst using the blower always be aware of the strength and direction of stream. Never direct the
blower discharge stream toward people or animals.
WARNING
Before performing maintenance on this machine,
stop the engine and disconnect the spark plug
wire.
Daily Maintenance
• Remove dirt and debris from the blower
exterior.
• Inspect the engine cooling fins for
accumulations of dirt or debris, and clean as
necessary.
• Inspect the entire machine for damage, loose
or missing components or fastenings, and
repair as necessary.
Every 10 Hours (More Frequently in Dusty
Conditions)
• Loosen the air cleaner cover retaining screw,
and remove the cover and filter element
• Inspect the element. If the element is distorted
or damaged, replace it with a new one.
ROUTINE MAINTENANCE
• Wash the element in clean fuel, and squeeze
or blow dry. Wash the air cleaner cover in
clean fuel, and wipe or blow dry.
• Install the element and cover, and the tighten
the cover retaining screw.
Every 10/15 Hours
• Use the spark plug wrench to remove the
spark plug (turn counter-clockwise to remove)
• Clean and adjust the spark plug gap to 0.6-
0.7mm. Replace any damaged or visibly worn
plug with a champion RCJ6Y or equivalent.
• Install the spark plug finger-tight in the cylinder
head, and then tighten it firmly with the spark
plug wrench. If a torque wrench is available,
torque the spark plug to 148-165 inch pounds.
Every 50 Hours
More frequently if you note reduced performance:
• Inspect the entire machine and tubes
for damage, including loose or missing-
components, and repair as necessary.