Bushranger 500SF, Инструкция по сборке и эксплуатации

Страница: 11 / 28

OPERATING THE LAWNMOWER
11
Starting the lawnmower - cold starts:
Starting the lawnmower - hot starts:
Stopping the engine:
Open the fuel shut off valve (where fitted).
Move the throttle control to choke / start
position. For lawnmowers fitted with non-
choke engines, the primer bulb must be firmly
pressed three to four times after the throttle
control lever has been moved to the run
position.
1. Grasp the starter grip and pull slowly until resistance is felt and then pull the starter
cord with a rapid, smooth movement to start the engine. Do not allow the cord to
snap back.
2. For models without a ‘zone start’ feature, place your foot against the mower body
then grasp the starter grip.
3. Repeat the starting procedure above if necessary.
4. When the engine starts, move the throttle to the run position and to the speed
desired.
5. In the case of flooding occurring, move the throttle to the stop position, pull
the starter cord 5 - 6 times, then move the throttle lever to the choke / start or run
position and pull the starter cord as above.
Follow the above #1 to #5 steps for restarting after emptying catcher or short rest periods. A
warm engine will usually start in the idle position. However, if it fails to start, follow the cold start
procedure.
To stop the engine, move the throttle control to the stop position. Turn the fuel shut-off valve
(where fitted) to the close / off position when the mower is not in operation to prevent fuel leakage
from the carburettor.
Never start or run the engine
indoors or poorly ventilated areas, e
ngine
exhaust contains carbon monoxide gas, which can
be fatal. Keep hands, feet, and clothing away from
moving parts.