Bushnell X-8 TRAIL CAM 119327, Инструкция по эксплуатации

Страница: 8 / 128

8
BATTERY and SD CARD INSTAllATION
The Bushnell X-8 Digital Trail Camera is designed to operate using 4 or 8
AA batteries. We recommend using a full set of 8 Lithium (for longest life)
or Alkaline batteries.
NOTE: Always set the power switch to the Off position when installing or
removing batteries.
Please make sure the batteries are inserted correctly, as indicated inside
the battery compartment. Incorrect voltage or polarity (+/-) will damage
the camera. The battery level meter on the top right of the display will
indicate when the internal batteries are low.
Do not mix old and new batteries.
Do not mix battery types-use ALL lithium or ALL alkaline.
Rechargeable batteries are not recommended.
Memory
Your X-8 Digital Trail Camera has a memory card slot, to accept SD cards
(sold separately) up to 32GB maximum capacity. If no SD card is inserted,
the display will flash “NOSD”, and the camera will not operate.
Inserting an SD card
• Make sure the power switch is in the
Off
position whenever adding
or removing memory.
• Insert an SD card into the card slot completely and oriented correctly
as shown by the icon above the slot (label up, contacts facing down
and notched corner on the right).
• To remove the SD memory card, depress the SD card and pull out
the card gently.
Using a new, blank SD card is recommended. If the SD card has been used
in another device, please make sure to format using the Format option
in the X-8 trail cam’s Setup menu before you set the camera to capture
photos/videos. New cards are ready to use straight from the package.