C
OUNTDOWN
T
IMER
A
LARM
Countdown / Reverse-Timer Mode
Press the
MODE
button until Countdown Timer Mode is
displayed, represented by ‘RT’ (reverse timer). To operate press the
UP
button to start and press again to stop, then press the
DOWN
button to reset the Countdown Timer.
To set the Countdown Timer press and hold down the
ADJ
button for
3 seconds, which will cause the seconds setting to blink. Adjust with
the
UP
or
DOWN
button, and then press the
MODE
button to
adjust next setting. Press the
ADJ
button to save settings and exit. Press
the
COMP
for ‘AUTO’ to allow Countdown Timer to repeat function
automatically, and press
COMP
again to turn off ‘AUTO’ function.
Press any button when alarm sounds to stop the Countdown Timer.
If nothing is pressed the Countdown Timer will stop beeping after
10 seconds, but it will continue if the ‘AUTO’ function is set on. To
stop the Countdown Timer if the ‘Auto’ function is on, you must go
to the Countdown Timer Mode and press
COMP
to turn off the
‘Auto’ function and then press
UP
button to stop it.
D
IGITAL
C
OMPASS
Compass Mode
Press the
MODE
button until Time Mode is displayed, and then
press the
COMP
button. If already in Time Mode, simply press the
COMP
button and Compass Mode is displayed. Hold the compass
level using the bubble level to get a reading. If the Cardinal Points
blink then the compass probably needs to be calibrated. (See trouble
shooting tips.)
Compass Calibration
In Compass Mode, hold down
ADJ
button for 3 seconds.
Calibration Mode is displayed. Put the compass on a level, non-
magnetic surface and press the
COMP
button. The word CAL will
start blinking. Then, rotate the compass 2 full circles slowly
WHILE
HOLDING THE COMPASS LEVEL
. When done, press
COMP
again. When completed, the display shows ‘DONE’ and it will then
go automatically into Declination Setting Mode. If Calibration is
Temperature Alarm
Sets the alarm to sound when the temperature measurement reaches
the programmed level. In the Alarm Mode, the Temperature alarm
uses the same measurement units (ºC or F) that were last set in the
Temperature Mode. To change this you must first change the
temperature units in the Temperature Mode. Using the
UP
or
DOWN
buttons once changes the temperature in tenths of a degree.
Holding either button down changes the temperature in increments
of 1 degree.
Beep Function
In the Alarm mode, a Beep function is also available. When
activated, the beep function causes a beep sound to be made
whenever a button is depressed, even when the Alarm function is
turned off. To activate the function go to the Beep function in the
Alarm Mode, press the
COMP
button and ‘ON’ is displayed. Press
again and ‘OFF’ is displayed.
Stopwatch Mode
Press the
MODE
button until Stop Watch Mode is displayed. To
operate, press the
UP
button to start and press again to stop.
Pressing the
DOWN
button will reset the Stop Watch.
For split timing function, press the
DOWN
button while the Stop
Watch is operating in order to stop the display and press again to
continue. You can also press the
DOWN
button while the Stop
Watch is operating to stop the display and then press the
UP
button
to stop the Stop Watch and display the final reading. Press the
DOWN
button again to reset the Stop Watch.
Stop Watch Mode / Split Timing Function
Split timing function is displayed as ‘SPL’ when activated and the
display returns to normal when
DOWN
button is pressed.
7
6