o
When moving the switch from “Off” to “Setup” or “On”, the user should
make sure that the switch stops in a positive position to ensure the proper
mode.
o
When moving the switch from “On” to “Setup”, the user should first move
the switch directly to “Off” before moving to “Setup”.
2.
LCD screen shows a faint black line after turning from “Setup” to “On”.
o
The LCD will turn off when you slide the switch to the “On” position. In
some cases, this black line will appear and will fade in about 1 second.
This is normal and the camera will function properly.
3.
Screen will come on and power off
o
Make sure that you have installed the SD card correctly.
Trophy Cam stops taking images or won’t take images
1.
Please make sure that the SD card is not full. If the card is full, the camera will
stop taking images.
2.
Check batteries to make sure that they are new alkaline or lithium AA batteries.
See note about short battery life.
3.
Make sure that the camera power switch is in the “On” position and not in the
“Off” or “Setup” modes.
4.
Make sure that you are using a good quality SD card in your camera. Bushnell
recommends San Disk Brand SD Cards.
Trophy Camera is taking images without subject in the field
of view
1.
Check the PIR Sensitivity Level Setting. For warm temperature use, set the sensor
to “High” and for cold weather use, set the sensor for “Low”.
2.
Try to set your camera up in an area where there is not a heat source in the
camera’s line of sight.
3.
In some cases, setting a camera near water will make the camera take images with
no subject in them. Try aiming the camera over ground.
4.
Try to avoid setting the camera up on small trees that are prone to being moved by
strong winds.
5.
Remove any limbs right in front of the camera lens.
Trophy Camera won’t power up
1.
Make sure that you have installed at least 4 batteries in the battery compartment
all stacked together at the top of the compartment.
o
Bushnell recommends 8 Energizer Lithium AA batteries in all Trophy
Cams.Make sure that the batteries are installed correctly. See manual.
