Installation
Water Connection
Caution:
2 people are required to unpack
and handle the appliance, it is recommended that
gloves are worn.
y
Carefully remove all packaging materials
including the foam base, dispose of correctly.
y
Connect the cold water supply hose to a
threaded ¾” connector and make sure that it is
fastened tightly in place.
y
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is clear.
This will prevent the water inlet to be blocked
and damage the appliance.
y
It can also connect the machine to a hot water
supply where it does not exceed 60
°
C.
Connection of drain hose
Insert the drain hose into a drain pipe with a
minimum diameter of 4cm, or let it
run into the sink, making sure to avoid bending
or crimping it. Use the special
plastic support that comes with the appliance.
Attention:
The special plastic hose support must be solidly
fastened to the wall to prevent the drain hose
from moving and allowing water to spill outside
the drain.
Position the appliance
1. The dishwasher must be installed on a solid
level surface.
2. Position the appliance in the desired location.
The back should rest against the wall behind
it, and the sides along the adjacent cabinets
or wall. The water supply and drain hoses
can be positioned either to the left or right
side to facilitate proper installation.
To level the dishwasher, adjust the 4 level
screws (feet) under the dishwasher.
4
