User Instructions
Using your appliance
To operate the dishwasher:
1. Make sure the water inlet and drain hose are correctly and securely connected.
2. Draw out the basket. Load the dishes (see the section "Loading the dishwasher").
3. Fill in the detergent (see the section entitled “Salt, Detergent and Rinse Aid”).
4. Make sure that the water supply is turned on to full pressure. Plug in the unit.
5. Rotate the washing selection knob, the wash program will be changed as follows
Intensive->Normal->Eco->Glass->Rapid->Soak;
Then press the Start/Reset button, the dishwasher begins to start.
Note:
When you press the Start/Reset button to pause during washing, the program light will stop
blinking and the dishwasher will mooing every minute unless you press the Start/Reset button to
resume the washing cycle.
Program Selection Change
You can modify the washing program, when the dishwasher just runs for a short time. Otherwise, the
detergent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the section entitled
" Loading the Detergent " ).
Press Start/Reset Button more than three seconds the machine will be in stand by state ,then you can
change the program to the desired cycle setting.
Note:
If you open the door during washing, the machine will pause. When you close the door and press
the start/reset Button, the machine will keep on working after 10 seconds.
The Start/Reset light shows the state of the dishwasher:
a) All program lights off --- Stand by
b) Any program lights on --- Pause
c) Any program lights blinking --- Running
14
