Bush RLBFO, Инструкция по эксплуатации, Страница: 14 / 36

Installing your Built-in Oven
Bringing it all together
Installing your Built-in Oven
14
If you require any technical guidance or find t at your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
Installation
This appliance should be installed by a competent person or qualified electrician in a accordance with the
regulations in force (All relevant British Standard/ Codes of Practice/relevant Building/IET regulations)and in
a well ventilated space. Please read instructions before installing and using this appliance.
Important: - The power supply to the appliance must be cut off before any adjustments or maintenance work is
carried out.
Installation of Built-in Ovens
In order to ensure that the built-in appliance functions properly, the cabinet containing it must be appropriate .The
figure below gives the dimensions of the cut-out for installation under the counter or in a wall cabinet unit.
595
59
5
565
22
59
5
565
595
200M
IN
22
200M
IN
45m
in
45
m
in
45
m
in
4
5
m
in
4
5
m
in
59
4
594
547
.8
5
7
7
.2
21
5
9
4
594
547
.8
5
7
7
.2
21
The worktop and any associated hob should be fitted BEFORE installing this oven.
It is recommended that if installing a built-in oven directly under the hob then there should be a
minimum air gap of 20 mm between the oven and the bottom of the hob. Failure to maintain a
suitable clearance may impair the performance of the hob.
Ensure that air can flow freely around the housing area. If the oven is being installed into a fully
enclosed built-under oven housing unit it may be necessary to cut a small slot in the top of the
plinth fitted under the unit. Cut a section 400 mm wide and a minimum of 15mm high to allow air to
pass under the unit. Alternatively cut a section 400 x450mm in the base of the carcass.
Failure to allow adequate ventilation to the appliance may result in overheating or damage to
adjacent units and could invalidate the guarantee.
Surfaces of furniture and walls adjacent to the appliance should be heat, splash and steam resistant.
All cabinet doors must be at least 4mm from the oven at all points.
Certain types of vinyl or laminate kitchen furniture are particularly prone to heat damage and
discolouration. We cannot accept responsibility for damage caused by normal use of the appliance
to any material that de-laminates or discolours at temperatures less than 65°C above room
temperature.
When placing the oven in the housing, do not use the oven door or handle as a lever for lifting the
oven as damage may result.
If you lower the oven door, you will see 4 screw holes, 2 on each side of the oven. The oven should
then be secured to the housing by fitting screws into these holes.