Bush NE-6216, Инструкция по эксплуатации

Страница: 8 / 9

13 14
„
Source- Buzzer/DAB/FM
If DAB or FM is chosen as the audio source you will also be
prompted to select the last played station or one of the preset
station (if set)
„
Daily/Once/Weekends/Weekdays
Choose the days on which the alarm is active
Note: if you choose “Once”, you are prompted to enter the require date.
„ Volume – Rotate the
SEARCH
control to increase or decrease the
volume you desired
This is the volume the alarm will build up to. (Initially the alarm
sounds at a low volume and gradually gets louder to the set volume)
„ Alarm – Off/ On
∞ In standby mode, active alarms are indicated by displaying the relevant
Alarm 1 and or Alarm 2 icons.
∞ At the set time, the alarm will sound, quietly at first, then gradually building
up to the set volume. When an alarm sounds.
To turn alarms on or off in standby mode
∞ Press the
ALARM/SNOOZE button, the display shows the current alarm
status. To switch the alarms on or off
∞ Press the
ALARM/SNOOZE button repeatedly to cycle through four states
as shown below (F.11)
∞ To choose the display Alarm status, press the SELECT button to confirm
Note 1:
If you have activated the alarm function and the wake up mode is
DAB or FM, make sure that the alarm volume level is set at a sufficient level
for you to hear.
Note 2: If one alarm arrive while the other is in snooze mode, snooze mode
will be canceled.
Alarm 1 : Off
Alarm 1 : Off
Alarm 1 : On
Alarm 2 : Off
Alarm 1 : Off
Alarm 2 : On
Alarm 1 : On
Alarm 2 : On
F.11
SNOOZE (AC OPERATION ONLY)
1. To temporarily silence a sounding alarm, press the
ALARM/SNOOZE
button once, you can change the snooze period by repeatedly pressing
the
ALARM/SNOOZE
button, Snooze periods are 5 or 10 minutes .
The radio returns to standby for the set time period with Snooze
countdown displayed. When the countdown reaches 0(zero) the alarm
triggered again. (F.12) (F.13)
2. Press the
STANDBY
button or the
ALARM/SNOOZE
button to fully
cancel a sounding alarm and switch the ratio to standby.
SLEEP (AC OPERATION ONLY)
This function allows you to program the unit to switch off by itself after a set
period of time.
1. Press and hold the
MENU/INFO button for longer than 2 seconds, then
rotate the
SEARCH
control until the display shows ‘System’, and press the
SELECT button to confirm. Rotate the SEARCH control until the display
shows “Sleep”
，
then press the
SELECT
button to confirm.
2. Rotate the SEARCH button that you can
choose the sleep delay time from:
Sleep Off /10/20/30/60/70/80/90
minutes
，
and then press the
SELECT
button to confirm. (F.14)
3. To check the sleep interval remaining,
rotate the
SEARCH control until the display shows “Sleep’, then press the
SELECT
button to check.
4. To cancel the sleep timer, press and hold the MENU/INFO button for
longer than 2 seconds, then rotate the
SEARCH
control until the display
shows ‘System’, and press the SELECT button to confirm. Rotate the
SEARCH
control until the display shows “Sleep”, then press the
SELECT
button to confirm. Rotate the SEARCH button to select “Sleep Off”, then
press
SELECT
button to confirm.
Snooze
5 minutes
F.12
07:03:45
Snooze 1:05
F.13
Set sleep time
30 minutes
F.14