Bush LCD40883F1080P, Инструкция по эксплуатации

Страница: 69 / 69

...and switch on
insert plug...
UK plug
Connect the aerial straight to your TV.
1
Insert batteries into the remote control.
2
Connect the TV to the mains socket.
3
5
Starting Auto Setup Procedure
LCD40883F1080P Helpline No: 0845 6040105
4
Switching the TV On
To start the automatic search, select
“Yes”,
to
cancel, select
“No”.
This process will take about five
minutes. To cancel searching, you can press the
“MENU”
button at any time during the process.
•
Press the
STANDBY
button
on the top panel. T
he
standby LED (Blue) will light up on the front.
Insert two
AAA/R3
or
equivalent type batteries
inside. Place the batteries
in the right directions and
replace the battery cover. After the
Automatic Search
is completed, the
following message asking for analogue channel
search appears on the screen
.
• To switch on the TV from standby mode either:
• Press the button,
P+ / P-
or a numeric button on the
remote control.
• Press the
-P/CH
or
P/CH+
button on the TV. The TV
will then switch on.
To search for analogue channels, press the
OK
button. The TV switches to the analogue TV mode.
The menu below will be displayed to search for
analogue channels. Press
OK
button to continue
.
Important note:
When the TV is turned on for the first time
YOU MUST
ALLOW
the digital tuning process to be completed,
EVEN IF
you only wish to use the analogue mode.
Note: Do not turn off the TV while initializing first time
installation.
When the TV is turned on for the first time, the menu
for the language selection appears on the screen. The
message
“Welcome please select your language!”
is displayed in all language options sequentially on
screen. By pressing
▲ or ▼ buttons highlight the
language you want to set and press “
OK”.
The following message appears on the screen:
After the APS has finished, program table will
appear on the screen. The stored local channels
are automatically assigned a program number. If
you would like to change the program order,
please refer to
Page 25
of the Instruction Book.
Connect the power cord to the 220-240V AC, 50 Hz.
HDMI to HDMI Cable Connection Selecting HDMI Input
To select the HDMI input, press the
SOURCE
button on the remote control. Each time it is
pressed the on-screen menu confirms your
selection.
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING. Use a
HDMI to HDMI cable to connect the two units
together.
To HDMI
connection
on the other unit.
50159511