Bush DW12LSINT, Инструкция по эксплуатации

Страница: 24 / 40

Using your Dishwasher
Getting the most from your appliance
Using your Dishwasher
24
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Fill the salt compartment with water the first time you
fill the salt compartment only.
Use softener salt specifically produced for use in
dishwashers.
When you start your dishwasher, the salt
compartment is filled with water, therefore put the
softener salt in prior to starting your machine.
If the softener salt has overflowed and you do not
start the machine immediately, run a short washing
program to protect your machine against corrosion.
P reparing your Dishwasher f or
f irst use
•
Check whether the electricity and supply water
specifications match the values indicated in the
installation instructions for the machine.
•
Remove all packaging materials inside the
machine.
•
Set the water softener level.
•
Fill the rinse aid compartment.
5 .1 Fill the salt (if available)
To fill with softener salt, open the salt compartment
cap by turning it counter clockwise. (1) (2) At first use,
fill the compartment with 1 kg salt and water (3) until it
is almost overflowing. If available, using the funnel (4)
provided will make filling easier. Replace the cap and
close it. After every 20th-30th wash, add salt into
your machine until it fills up (approx. 1 kg).
SALT
3
4
1
2
The dishwasher is equipped with a water softener
which reduces the hardness in the mains water
supply. To find out the hardness level of your tap
water, contact your water company or use the test
strip (if available).
5.2 W ater S o f tener S ystem
5. 3 S etting W ater H ardness level
•
Turn the knob to the “0/Reset” position.
•
Push the “Start/Pause” button and hold down.
•
Turn on the machine.
•
Hold down the “Start/Pause” button until the
lights flash and “SL” disappears.
•
The machine will display the last setting.
•
Set the level by pushing the “Start/Pause”
button.
•
Switch off the machine to save the setting.