Bush CMC1113DABBT, Инструкция по эксплуатации, Страница: 39 / 56

Using your Micro System
Let’s get started
Using your Micro System
39
section of these instructions, or online at
www.argos-support.co.uk
If you still require further assistance, call one of our experts on
0345 600 3021
.
Connecting a Bluetooth device
When using the Bluetooth connection, you can listen to audio wirelessly from a Bluetooth
audio device (For example an MP3 player) within 10 metres of the Micro System unit.
1.
Make sure you are in BT input mode (refer to page 20).
2. When selected the ‘BT LINK’ text on the display will flash while the system tries to
connect to previously paired devices. If no devices are found the ‘BT LINK’ text will
continue to flash to indicate it is ready for pairing a new device.
3.
Enable the Bluetooth function on your audio device and search for a device labelled
‘CMC1113DABBT’ in the available list.
4. Select and enable pairing for the ‘CMC1113DABBT’ device. If prompted for a password
enter ‘0000’.
5. If pairing is successful the micro system will play a melody and the ‘BT LINK’ text will
stop flashing.
If you turn off either device before pairing is complete the process will need to be
repeated when powered ON again.
6. If the connected device goes out of range, the micro system will attempt to connect
for 2 minutes. When the device comes into range the unit will reconnect again
automatically.
7.
To remove a paired device using the micro system, press and hold the UNPAIR/ENTER
button on the micro system or press the UNPAIR button on the remote The ‘BT LINK’
text will begin flashing again.
If using a mobile phone as an audio source, when receiving a phone call the audio
playback stops while you receive the call. When you hang up the audio is restored.
The volume output is effected by the volume level on the audio source EG: Phone or
laptop, so make sure that is set to about 70-80% (not too loud to avoid distortion).