Bush BFSLNB9B, Инструкция по эксплуатации

Страница: 31 / 41

Care and maintenance
Care and maintenance
Looking after your appliance
Cleaning
Cleaning your Dishwasher is important to maintain the
machine’s service life.
Oil and lime
scale may build up in your Dishwasher
over time. If this occurs:
•
Fill the detergent compartment but do not load
any dishes. Select a programme which runs at
high temperature and run the Dishwasher empty.
If this does not clean your Dishwasher
sufficiently,
use a cleaning agent designed for use with
dishwashers.
•
Wipe the door seals regularly with a damp cloth
to remove any accumulated residue.
Cleaning machine and filters
Clean the filters and spray arms at least once a week.
If any food waste remains on the coarse and fine
filters, remove them and clean them thoroughly with
water.
a) Micro Filter
b) Coarse Filter
c) Metal Filter
To remove and clean the filter combination, turn it
counter clockwise and remove it by lifting it upwards
(1).Pull the coarse filter out of the micro filter (2).Then
pull and remove the metal filter (3).Rinse the filter with
lots of water until it is free of residue. Reassemble the
filters. Replace the filter insert, and rotate it clockwise
(4).
•
Never use your Dishwasher without a filter.
•
Incorrect fitting of the filter will reduce the
washing effectiveness.
•
Clean filters are necessary for proper running of
the machine.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at
www.argos-support.co.uk
If you still require further assistance, call one of our experts on
0345 257 7271.
2
b
a
1
3
4
c
Spray arms
Make sure that the spray holes are not clogged and that no
food waste is stuck to the spray arms. If there is any
clogging, remove the spray arms and clean them under
water. To remove the upper spray arm undo the nut
holding it in position by turning it clockwise and pulling it
downwards. Make sure that the nut is properly tightened
when refitting the upper spray arm.
30