Bush 311010, Инструкция по эксплуатации

Страница: 13 / 32

Getting to know your LED Speaker
You’ll be up and running in no time
Getting to know your LED Speaker
13
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021
Initial set-up
1. Slide the On/Off switch on the back of the product to On. Your LED speaker will
switch on and announce the current mode e.g. ‘Bluetooth mode’ or ‘Aux in mode’.
Change the mode
1. Press and release the M button to change between Bluetooth and Aux in modes.
Your LED Speaker will announce each mode as you change to it
Connect to a Bluetooth device
NFC touch point
Your LED Speaker has an NFC touch point to enable quick and easy Bluetooth pairing with
other NFC enabled devices.
Check that your LED Speaker is in Bluetooth mode. If you are not already in Bluetooth
mode, press and release the M button until you are in Bluetooth mode.
1.
When the small blue LED on the top of the LED Speaker is flashing, just touch your
other NFC enabled device to the NFC touch point logo on the top of your LED
Speaker. When pairing is complete the blue LED will stop flashing and will remain
constantly on. The LED Speaker will announce ‘Bluetooth paired’.
Note:
The Bluetooth name of your LED Speaker is BUSH LED SPEAKER.
2.
To disconnect an NFC Bluetooth connection, just touch your other NFC enabled
device to the NFC touch point logo again. After disconnection, the small blue LED will
start to flash again and your LED Speaker will announce ‘Bluetooth disconnected.