MS250G, MS500G, MS800G, MS500P, MS800P
Compact Manure Spreader
Service and Maintenance
37
9.7.2 Replace the Drive Belts
IMPORTANT! Always replace drive belts as a matched set.
Recheck the drive-belt tension after 10 hours of use.
01398
1
2
Fig. 31 –
Tensioning a Drive Belt
1.
Remove the belt-drive shield.
2.
Loosen (do not remove) the four bearing-mount bolts (1).
3.
Turn the drive-belt tensioning nut (2) counterclockwise to
loosen it.
4.
Push down on the drive belts to pull the bearing over until
the drive belts are loose enough to remove.
5.
Remove the drive belts, and then install a new set of belts.
6.
Slide the bearing to snug up the belts.
7.
Turn the belt tensioning nut clockwise to apply tension.
8.
Check the drive-belt tension. For instructions, see
the Drive Belt Tension on page 36
.
9.
Make sure that the pulley alignment is correct, and then
tighten the four bearing-mount bolts.
10.
Reinstall the belt-drive shield.
9.8 Beater-bar Paddles
For optimal performance, inspect the beater-bar paddles on a
regular basis and replace paddles that are worn or damaged.
Contact your Bush Hog dealer to purchase replacement paddles.
2
1
4
3
01468
Fig. 32 –
Beater-bar Paddle Replacement
1.
Set the machine to a safe condition. For instructions, see
.
2.
Rotate the beater bar to access the required paddle (2).
3.
Remove the three bolts (3) and serrated nuts (1) that
secure the paddle to the paddle holder (4), and then remove
the paddle.
4.
Align a new paddle with the bolt holes.
5.
Install the three bolts and nuts to secure the paddle to the
pallet holder (if required, use new fasteners).
6.
Tighten the paddle bolts and nuts to the recommended
torque. For more information, see
.
7.
Repeat Steps 2–6 for each additional paddle that requires
replacement.
Содержание MS250G
Страница 44: ...BUSH HOG...