Bush Hog MS1300P, Руководство оператора, Страница: 20 / 44

PTO Shaft
MS1300P
Manure Spreader
20
6.2 Installing a PTO Shaft
Make sure that the equipment is in the following state:
• The tractor is turned off and the parking brake is applied.
• The PTO shaft shielding is in good condition and able to
turn freely, independent of the PTO shaft.
• The PTO yoke ends are clean. Adding a small amount of
lubricant on the splines can help them to slide on.
00866
Fig. 11 – Locking-Pin Button
1. Install the PTO shaft on the implement:
a. Press the locking-pin button and push the shaft end
onto the input PTO.
b. Connect the safety chain to the implement, so that the
shielding does not turn during operation.
2. Slide out the end of the PTO shaft up to the tractor output
PTO, aligning the two shaft splines.
3. Press the locking-pin button and push the shaft end onto
the tractor output PTO.
4. Once it is started, slide the shaft all the way on. You might
hear a click and the locking-pin button should retract to the
original position.
5. Check that the shaft lock is fully seated by taking your
hands off the locking-pin button, and then pulling back on
the shaft.