Bush Hog HDC2361FX, Руководство оператора, Страница: 53 / 104

CONTROLS
CONTROLS
HDZ ZT 01/17 Controls Section 3-5
©
2016 Alamo Group Inc
.
PTO Switch
The PTO Switch is located on the Console and is Yellow
in color.
To engage the Zero Turn mower blades pull the PTO
Switch switch up and to disengage push the switch down.
NOTE: The PTO Switch should only be engaged when
the engine is running and the steering levers are in
the Neutral position. The Zero Turn Mower will not
start if the PTO Switch is pulled up prior to starting
the Zero Turn Mower. It must always be in the OFF
(Down) position to start.
The Fuel Tank is located under the operators seat and
the Filler Neck is located on the left hand side toward the
rear of the seat. The Fuel Cap is tettered to the tank to
avoid dropping when refueling the Zero Turn Mower.
Gasoline is highly flammable. The en-
gine and exhaust system become
very hot during operation.
Allow engine and exhaust system to cool down before re-
fueling the Zero Turn Mower.
Use CAUTION and only fill outdoors.
Fill to the bottom of the filler neck (DO NOT OVER FILL).
Do not fuel the Zero Turn Mower near an open flame.
Clean away any spilled fuel after re-fueling and before
re-starting the Zero Turn Mower.
Check the gas fill cap often for damage to gasket. If dam-
aged replace the fill cap.
The engine is designed to operate on 87 Octane un-
leaded gasoline.
Damage to the engine may occur if E85 Alcohol based
fuel or Methanol fuel is used.
The Cutting Height is controlled by pushing the Foot Con-
trol Pedal all the way forward and turning the Height Ad-
justing knob to the desired cutting height and aligning
with the indicator point on panel. Release the pressure
on the Foot Control Pedal until it stops at the set cutting
height.
PTO
Switch
Cutting Height Controls
Fuel Tank and Filler Neck
IMPORTANT: To maintain an even cutting
height, all tires must have equal air pressure
of 15 psi /103kPa / 1bar.
Filler
Neck
&
Fuel
Cap
!
WARNING!
IMPORTANT: Always raise the Zero Turn
Mower Deck to the highest position and disen-
gage blades when transporting.
Foot Control Pedal
Height Control Knob