Bush Hog 12814, Руководство оператора, Страница: 92 / 206

INTRODUCTION
2814-2820 08/20 Introduction Section 2-4
© 2020 Alamo Group Inc.
INTRODUCTION
Equipment Specifications
2814 / 12814 2820 / 12820 2814 / 2820 12814 / 12820
Cutting Width 14’ 20’
Blade Tip Speed 540 PTO 1000 PTO
Transport Width 9’ 12’ Center 15,625 FPM 15,994 FPM
Overall Width 14’-6” 20’ - 10-1/2” Wings 15,834 FPM 15,936 FPM
Overall Length 17’-2” 17’ - 5”
Cutting Height 2”-14” 2” -14”
Gearbox Rating
HP Required (min) 90 PTO 90 PTO Power Divide 250 HP 250 HP
Cutting Capacity (max) 3” 3” Center & Wing 225 HP 225 HP
Drawbar Load Rating (min) 2,585 lb. 2,585 lb. Limited Warranty 10 Year 10 Year
Wing Flex Up 87° 87°
Driveline Size
Wing Flex Down 22° 22° Main CAT 6 CAT 6
Wing CAT 5 CAT 5
KEY OPERATION POINTS
• Cutting performance and distribution are best when cutter is level from side to side. Mower front to rear
pitch should be 1” or less.
• In extra heavy material, rear chains will allow better discharge.
• Never operate the Flexwing below full PTO speed of 540 or 1000 rpm.
• For good distribution, the distribution baffles must be used.
• Make sure PTO driveline slip clutches are not frozen and are properly adjusted.
• To reduce uneven grass cutting and streaking.
- make sure tractor rear tire spacing is a minimum of 60” between the inside of the tires.
- make sure blades are not bent and are in good condition.
- reduce ground speed to allow more cutting time.
• If Tractor engine is lugging down, shift tractor to a lower gear
• ALWAYS OPERATE WITH THE WING HYDRAULIC CYLINDER CONTROL VALVES IN A FLOAT
POSITION.
• For maximum performance and service life, Always use Genuine Bush Hog replacement parts