DRILL PRESS MANUAL
We reserve the right of the amendment addition and deletion of the
specifications, explanatory wording, etc. printed in this manual
6
drill bit size and the material that you are drilling.
2. FEED THE DRILL BIT EVENLY INTO THE WORKPIECE.
Back the bit out of deep
holes and clear the chips with a brush after you have turned the machine off.
3. MAKE SURE THE DRILL BIT YOU ARE USING IS TIGHTENED PROPERLY.
Use
only round, hex or triangular shank drill bits.
4. NEVER DO MAINTENANCE OR CHANGE SPEEDS WITH THIS MACHINE
PLUGGED IN.
5. NEVER USE TOOLS THAT ARE IN POOR CONDITION.
Cutting tools that are dull or
damaged are difficult to control and may cause serious injury.
6. NEVER DRILL SHEET METAL UNLESS IT IS CLAMPED SECURELY TO THE
TABLE.
7. WORK SHOULD BE POSITIONED IN SUCH A WAY AS TO AVOID DRILLING INTO
THE TABLE.
8. A FACE SHIELD USED WITH SAFETY GLASSES IS RECOMMENDED.
9. ALWAYS CLAMP WORKPIECE SECURELY TO TABLE BEFORE DRILLING.
Never
hold a workpiece by hand while drilling.
10. IF AT ANY TIME YOU ARE EXPERIENCING DIFFICULTIES
performing the intended
operation, stop using the machine! Then contact our service department or ask a
qualified expert how the operation should be performed.
11. REMOVE ADJUSTING KEYS AND WRENCHES.
Before turning the machine on,
make it a habit to check that all adjusting keys and wrenches have been removed.
12. HABITS
—
GOOD AND BAD
—
ARE HARD TO BREAK.
Develop good habits in your
shop and safety will become second-nature to you.
2.CIRCUIT REQUIREMENTS
Grounding
In the event of an electrical short, grounding reduces the risk of electric shock by providing
electric current a path of least resistance. This tool is equipped with a power cord having
an equipment-grounding conductor.
See Figure 1.
The outlet must be properly installed
and grounded in accordance with all local codes and ordinances.
文件使用
"pdfFactory Pro"
试用版本创建
