DRILL PRESS MANUAL
We reserve the right of the amendment addition and deletion of the
specifications, explanatory wording, etc. printed in this manual
15
2.
Always lock the table rotation in place before operating the machine.
Adjust angle:
1.
Turn the nut indicated by the arrow in
Figure 17
, in a clockwise direction. This will draw
the location pin out of the casting. Once loose, pull the pin and nut out, and set it in a
safe place until needed.
2.
Loosen the large bolt in the center of the support bracket.
3. Rotate the bracket to the desired angle. Use the scale on the side of the bracket or a
protractor to set the angle. Lock in place by tightening the bolt.
Figure 17 Figure 18
When repositioning the table to 0
°
position, loosen the large bolt in the center of the
support casting. Rotate the support casting until the degree scale reads 0
°
. Carefully tap
the location pin back into the hole from which it came until it stops. Unscrew the nut on the
location pin until it is flush with the end of the threads. This will protect the threads when
you tap it into place with a hammer. Turn the nut clockwise until it is snug against the
casting and then tighten the large bolt in the center. The table is now set to the factory
pre-set angle.
6: OPERATIONS
Test Run
Once assembly is complete and adjustments are done to your satisfaction, you are ready
to test run the machine.
Turn on the power supply at the main panel. Flip the START button. Make sure that your
finger is poised on the paddle switch, just in case there is a problem. The drill press should
run smoothly, with little or no vibration or rubbing noises. Strange or unnatural noises
should be investigated and corrected before operating the machine further.
If you cannot easily locate the source of an unusual noise or vibration, contact our service
department for help.
Drill Bit Changes
文件使用
"pdfFactory Pro"
试用版本创建
