MM3156A DRUM SANDER
１４
Conveyor Tabel Mounting Bolts
Figure 9
2. Slide one or both of the shims (not supplied) as needed under the edge of the
conveyor tabie as shown.
3. Tighten conveyor table mounting bolts. Re-check the measurement at A and at B.
4. Test sand a piece of wood and check for uniform thickness.
If the measurement at A exceeds B by more than .020”, or if distance B is greater than A,
proceed as follows:
1. Loosen the two front and two rear adjistment bolts as shown in Figure 10, thus
allowing the entire drum assembly to pivot.
