7
Assembly and Set-Up
WARNING:
Failing to properly adjust and
tighten the bolts that affix the
handlebars can cause you to
lose control and crash.
Turn power switch “OFF”
before conducting any
maintenance procedures.
All Models are preset on low
speed at the factory see page
9
for information on the
Hi-Low speed switch.
TT350
/450/750R
- light switch
is located on the throttle
control.
TT250
- battery charge
indicator is located on throttle
control.
Attaching the Handlebars
Tools required: 6mm Hex Key wrench
1. Place the handlebars in the handlebar clamps.
Make sure cables are not twisted or kinked.
2.
Center handlebar in clamps and position to fit
the rider height. Tighten the bolts using a 6mm
Allen wrench. When properly tightened, you
should have a small gap in front and back of
each clamp. The handlebars should not move
forward or back.
3.
Rotate the front fork from side to side making
sure that the wires and cable are free. Squeeze
the brake handle a couple times to loosen up the
brake. Spin the rear wheel making sure it spins
free. Without brake drag
